免费发布
客集网 » 机械设备 » 泵及真空设备 » 进口潜水混流泵(欧美进口十大品牌)

进口潜水混流泵(欧美进口十大品牌)

  • 供应商:上海秉奇阀门有限公司 [进入公司网站]
  • 所在地:上海
  • 价格:面议
  • 更新时间:2019-09-11 15:41
  • 13524269805| 021-51698378
  • 联系人:黄颖周(先生) 经理 (来电时请说是从客集网看到我的)
  •        [诚信档案]

英国GRIMM格林进口潜水混流泵 UK GRIMM imported submersible mixed flow pump

进口潜水混流泵.jpg

英国GRIMM格林进口潜水混流泵概述: 

          进口潜水轴流泵是传统的水泵电动机机组的更新换代产品,驱动水泵的电动机是干式全封闭潜水三相异步电动机,该型潜电泵可长期浸入水中运行。具有传统机组一系列无可比拟的优点。

⑴由于电机和水泵构成一体,现场安装方便、快捷,同传统机组相比可节约95%安装时间;
⑵由于电机潜入水中运行,电机冷却条件好,泵站内无高温,噪音低,可建成地下泵站,保持地面的环境风貌,大大简化了泵站的土工及建筑结构工程,减少安装面积,可节省工程造价30~40%;
⑶潜水电机采用双重、三重机械密封及辅助密封结构,F级耐高温155℃绝缘,防护等级为IP68。且在电机内设置密封泄漏、绕组和轴承温升检测装置。

⑷检测信号集中反馈于电控柜的监控器内,操作方便,易于实现自动控制及远程控制。

英国GRIMM格林进口潜水混流泵结构说明: 

             潜水电泵的潜水电机置于泵的上方,潜水电机为干式结构,采用F级绝缘,可靠的机械密封及辅助密封,并设有泄漏和内部绕组、轴承温升保护装置,配备控制柜、运行安全可靠,运载水质和环境适应广、叶片可调、工况范围大。
          泵段由进水喇叭口,叶轮件,叶轮外壳和导叶体四大零件组成。潜水电机是全密封干式异步电动机,机壳将电机封闭,电机上端电缆出线处有静密封装置,电机下端盖出轴处有转动密封装置,潜水电机具备一切潜水运行的安全可靠性能。
          从进水口方向看,叶轮为逆时针方向旋转。
          当电机功率在315KW以下时,电压采用380V或600V,当电机功率在315KW以上时,电压采用6KV或10KV。

英国GRIMM格林进口潜水混流泵技术参数:

流       量:800-11000m3/h
扬       程:1.0-10m
口       径:350-2000mm
转       速:215-1450r/min
功       率:15-710kw
电       压:380V、600V、6KV、10KV
介质温度:50℃

英国GRIMM格林进口潜水混流泵主要用途、使用环境: 

          潜水电泵可广泛适用于工矿船坞、城市给排水、农田排灌、电站给排水之用。潜水轴流泵用于低扬程、大流量场合。上述产品输送介质为原水或轻度污水,其zui高输送液体温度为50℃,输送介质的PH值为4~10,输送的介质的容积比在2%以下,介质的密度小于1.2  103kg/m3。乘以该产品是解决水位涨落较大的沿江、湖泊地区防洪问题zui彻底的办法。

UK GRIMM imported submersible mixed flow pump summary:

           imported submersible axial pump is a new product of the traditional water pump motor unit. The motor driving the water pump is a dry closed submersible three-phase asynchronous motor. The submersible pump can be immersed in water for a long time. Have a series of incomparable advantages of traditional units.

Because the motor and pump together, installation is convenient and fast, compared with the traditional unit can save 95% installation time;

Because the motor run in the water, cooling conditions, pump station without high temperature, low noise, can be built underground pumping station, to keep the ground environment, which greatly simplifies the geotechnical and structure engineering of pumping station, reducing installation area, save the project cost from 30 to 40%;

The submersible motor with double and three auxiliary mechanical seal and sealing structure, insulation grade F high temperature of 155 DEG C, the protection class is IP68. A sealing leakage, a winding and a bearing temperature rise detecting device are arranged in the motor.

The detection signal feedback on the monitor in centralized control cabinet, convenient operation, easy to realize automatic control and remote control.

UK GRIMM imported submersible mixed flow pump structure description:

           Above the submersible motor pump at the submersible pump, submersible motor for dry structure, using F class insulation, reliable sealing and auxiliary seal, and a leakage and internal winding, bearing temperature rise protection device, equipped with control cabinet, safe and reliable operation, carrying water quality and the environment to adapt to a wide, adjustable blade, wo**ng condition large range.

        The pump section is composed of four parts: water inlet bell ring, impeller part, impeller shell and guide vane. The submersible motor is fully sealed dry type asynchronous motor, the motor casing is closed, the upper end of the motor cable outlet static sealing device, a lower end cover of the motor shaft rotation sealing device, the submersible motor has safe and reliable performance of all diving operation.

        From the direction of the inlet, the impeller rotates counter clockwise.

        When the motor power is below 315KW, the voltage is 380V or 600V, and when the motor power is above 315KW, the voltage is 6KV or 10KV.

UK GRIMM imported submersible mixed flow pump technical parameter:

Flow rate: 800-11000m3/h

Lift: 1.0-10m

Caliber: 350-2000mm

Speed: 215-1450r/min

Power: 15-710kw

Voltage: 380V, 600V, 6KV, 10KV

Medium temperature: 50 DEG C

UK GRIMM imported submersible mixed flow pump main use and use environment:

        Submersible pump can be widely used in industrial and mining, dock, urban water supply and drainage, irrigation and drainage, power station water supply and drainage. Submersible axial pump is used for low lift and high flow occasions. The above product delivery medium for raw water or mild sewage, the highest delivery liquid temperature is 50 degrees, the transmission medium pH value of 4~10, conveying medium volume ratio below 2%, medium density is less than 1.2 103kg/m3. Multiplying this product is the most thorough solution to the flood control problem in the areas along the Yangtze River and lakes wher the water level fluctuation is greater.

也不满意?产品主动找你!